Rug mat stain cleaning method inventory

The method used by most people to maintain the carpet is to clean it with a vacuum cleaner. Therefore, when the carpet cleaning is introduced in this article, it starts with cleaning the vacuum cleaner. However, the methods described in this article do not stop there. We will provide separate guidance on cleaning, removing stains and dealing with various other issues.

First, pay attention to the following basic matters:

Carpets are cleaned once a week with a vacuum cleaner, and frequent stampings require frequent cleaning. Frequent cleaning with a vacuum cleaner prevents sand accumulation and prolongs the life of the carpet because too much sand will break carpet fibers. Every few weeks, spend more time using crevice cleaning tools to clean the siding, heating, and other inaccessible areas.

Use a vacuum cleaner to clean the carpet covering the entire floor. Divide the floor into four parts and clean each part of the carpet one by one.

It will take time to clean the carpet with a vacuum cleaner. It will take time to clean up the plush carpet with dirt in it. It is not enough to clean it with a high-powered upright vacuum cleaner. Each part of the carpet should be carefully inspected several times, the slow operation so that the suction device can remove all the dust and dirt inside the carpet.

Pay special attention to those places where people sit and move their feet. When using a vacuum cleaner to clean these frequently stepped places, you can use a cross-shaped cross-moving method.

New carpets or newly cleaned carpets can also be sprayed with a little antifouling finish. Please follow the manufacturer's recommendations when spraying. The antifouling finish can only be sprayed with professional equipment according to the recommended method.

Add baking soda to the dirt collection bag of the vacuum cleaner to eliminate the odor.

Smells are minor problems, and stains are much more troublesome. Almost every carpet will have stains that are difficult to remove. In the next section, we will provide some ways to remove stains.

For stains on carpets, the first principle is to clean them immediately. If stains are found on the carpet soon after they are found, they are most easily removed completely. Please also consider the following tips:

Before using any cleaning solution, carefully blot or scrape off the entire stain. Remove stains as much as possible.

Before using any cleaning solution, perform tests in an unobtrusive place on the carpet to ensure that the detergent will not damage the carpet or discolor the carpet. Use an existing cleaning agent before testing to ensure that it does not damage the carpet.

Please do not wipe the stains as this may make the stain larger.

When using detergents, clean the stain from the outside to the inside to avoid scaling up. After using the cleaning solution, the liquid is sucked dry.

To dry the carpet and wipe the fluff from the carpet upright, using a clean white bath towel is best.

If the carpet is still wet after being blotted, place a stack of white towels about 1.9 centimeters thick in a damp place and press the weight onto the towel.

What if the carpet is covered in chocolate? What if I get urine? What should I do if I get mud? In the next section, we will answer the above questions and other questions.

Tips: Homemade Carpet Freshener

Here is a recipe for a homemade carpet freshener:

1 cup grated dried herbs (rosemary, artemisia and lavender are all on the list)
1 teaspoon clove powder
1 teaspoon ground cinnamon
1 teaspoon baking soda

Reconcile the above ingredients and sprinkle the blended mixture on the carpet. This mixture is left on the carpet for several minutes and then removed with a vacuum cleaner.

Here are the other two mixtures:

Add a few drops of your favorite floral oil to a small box of baking soda and sprinkle it on the carpet as a refresher. Let this mixture act on the carpet for 10 to 20 minutes and then remove it with a vacuum cleaner.

Mix 1 cup baking soda, 1 cup of corn starch, and 15 drops of essential oil. Let this mixture act on the carpet for 10 to 20 minutes and then remove it with a vacuum cleaner. The formulated mixture is stored in a glass bottle or a sealed container.

There may be too much stuff on the carpet, such as wine, chewing gum, and so on. In this section, we will show you how to remove a variety of specific stains.

Acid stains: Acid stains such as scale removers and vinegar need to be handled quickly. Immediately dilute the solution with baking soda or soda. Then, pour a solution of 1 part of ammonia to 10 parts of water on the stain. Rinse with cold water, dry it, and clean it with a vacuum cleaner.

Alcoholic drinks: Quickly dilute the stains with cold water. Suction excess liquid. Then mix the solution with 1 teaspoon of detergent, 1 teaspoon of white vinegar, and about 1 liter of warm water. Pour the solution over the stain and dry the carpet. Clean it slowly with a vacuum cleaner.

Bloodstains: As much as possible to suck dry blood. Then mix the solution with 1 teaspoon of detergent, 1 teaspoon of white vinegar, and about 1 liter of warm water. Pour the solution over the stain and dry the carpet. Pour dry-cleaning liquid. After the carpet has dried, clean it slowly with a vacuum cleaner.

Butter: Scrape butter as much as possible. Pour dry-cleaning liquid and dry the carpet. If the stain is still there, repeat the above steps. Clean it slowly with a vacuum cleaner.

Wax: Press small square ice cubes on wax stains. After the wax has hardened it can be removed.

Sauce stains: Pour a cup of vinegar to a mixture of 2 cups of water and pour it over the stain. Wipe it with a sponge. Twist the sponge, wipe, and wring again until the stain disappears.

Chewing Gum: Chewing gum sticks to the carpet and soils the carpet, so press it against the sticky chewing gum to make it hard. After the chewing gum is hardened, it can be removed.

Chocolate: Immediately scrape chocolate off the carpet. Mix with 1 teaspoon detergent, 1 teaspoon of white vinegar, and about 1 litre of warm water. Pour the solution on the stain. Then rinse it. Clean it slowly with a vacuum cleaner.

Coffee: Immediately dry the coffee spilled on the carpet. Then mix the solution with 1 teaspoon of detergent, 1 teaspoon of white vinegar, and about 1 liter of warm water. Pour the solution over the stain and dry the carpet. Pour dry-cleaning liquid. After the carpet has dried, clean it slowly with a vacuum cleaner.

Crayons: You can scrape off the crayon grease that is stuck to the carpet; you can also remove the grease by using the following method: put the blotter paper on the crayon grease, and press it on the blotting paper with an iron until the blotting paper will Melted crayon grease blotted dry. Move the blotter from time to time to prevent it from getting saturated. Pour dry-cleaning liquid and dry the carpet. Clean it slowly with a vacuum cleaner.

Fruit crumbs: Fruit juices are difficult to remove if they stick to carpets. However, permanent stains are usually avoided if they are treated as follows. Scrape off the stain on the carpet and blot the juice. Mix with 1 teaspoon detergent, 1 teaspoon of white vinegar, and about 1 litre of warm water. Pour the solution over the stain and dry the carpet. If the stain is still there, repeat the above steps. Clean it slowly with a vacuum cleaner.

Gravy: Wipe the gravy sprinkled on the carpet as much as possible. Mix with 1 teaspoon detergent, 1 teaspoon of white vinegar, and about 1 litre of warm water. Pour the solution on the stain. Dry the carpet. Pour dry-cleaning liquid and dry the carpet. Clean with a vacuum cleaner.

Mud: After the mud has dried, brush or scrape it as much as possible. Mix with 1 teaspoon detergent, 1 teaspoon of white vinegar, and about 1 litre of warm water. Pour the solution on the stain. Dry the carpet. If stains are still there, pour dry-cleaning liquid and dry. After the stain is dry, clean it slowly with a vacuum cleaner.

Salad dressing: As much as possible to dry salad sauce. Mix with 1 teaspoon detergent, 1 teaspoon of white vinegar, and about 1 litre of warm water. Pour the solution on the stain. Dry the carpet. If the stain is still there, repeat the above steps. Clean it slowly with a vacuum cleaner.

Soft drinks: Soft drinks contain carbon dioxide, which helps you quickly clear the drinks on the carpet, but still have to deal with it quickly, because some of the color in the drinks may leave a permanent stain on the carpet. Drain the drink on the carpet. Mix with 1 teaspoon detergent, 1 teaspoon of white vinegar, and about 1 litre of warm water. Pour the solution on the stain. Dry the carpet. If the stain is still there, repeat the above steps. Clean it slowly with a vacuum cleaner.

Urine: Mix 1 teaspoon detergent, 1 teaspoon white vinegar, and about 1 litre of warm water. Pour the solution on the stain. Dry the carpet. If the stain is still there, repeat the above steps. Clean it slowly with a vacuum cleaner.

Vomit: Vomits should be handled quickly. Efforts should be made to remove vomit as much as possible, and then immediately use baking soda to replenish the water solution or soda to dilute the stain. Pour a solution of 1 part of ammonia to 10 parts of water on the stain. Rinse with cold water, dry it, and clean it with a vacuum cleaner.

Wine: If the red wine is spilled on the carpet, white wine is used to dilute it, then the stain is washed with cold water, and the salt is washed after cleaning. Wait ten minutes and remove the salt with a vacuum cleaner.

If none of the above methods work, you may need to try thorough cleaning. Thorough cleaning is the topic of the next section.

During the carpet's life, sometimes cleaning with a vacuum cleaner does not restore the carpet's clean appearance. There are four main criteria for judging whether there is a need for thorough cleaning: the carpet is tangled and it is visibly sticky; the colour of the carpet is no longer the same as the colour of the trim of your new carpet; the carpet around the chair has a full circle of stains; The carpet is filled with dust when you run through the room.

If your carpet meets any of the four conditions above, it will need to be thoroughly cleaned. If you don't have the time and energy to do a thorough cleaning yourself, it is best for professionals to do it. There is only one way to clean both the front and back of the carpet. It is to use a carpet cleaner (use detergent) to agitate and then rinse with a dehydrator. The steps are as follows:

Before you clean the carpet, check whether the carpet will fade. Use a cleaning solution (the one you plan to use to clean the carpet) to soak a white towel, then use a white towel to wipe an inconspicuous spot on the carpet. If the towels are not covered with the color of the carpet, it is likely that the use of such cleaning fluids on the entire carpet is safe.

Try to remove the furniture as much as possible. The rest should be affixed with foil or plastic sheets on the furniture legs or the bottom of the furniture to avoid marking on the carpet.

First clean the carpet thoroughly with a vacuum cleaner, then clean and pre-treat the stains, and finally clean the carpet with a carpet cleaner.

Follow the instructions on the carpet cleaner.

Use a single stroke on the carpet surface.

Do not use high pressure cleaners.

Immediately wipe off the cleaning fluid and foam from furniture legs and woodwork to prevent damage.

After washing with a washing machine, shake the damp carpet and let it dry faster.

Make sure the room is ventilated after cleaning to make the carpet dry faster.

Do not walk on the carpet until it has completely dried.

In the last section, we will tell you how to deal with some special carpet problems, such as burn out and off the line.

If your carpet has burned, stained or faded, just put a big chair in place and forget about it. You can also use the following simple method to restore the carpet to its original appearance.

If the stain remover you use will discolour the carpet, try using an acrylic paint applied by the painter to trim small areas. If the acrylic paint does not work, try a colored felt tipped marker pen or permanent ink marker.

The Knock Sensor is located on the engine block, cylinder head or intake manifold. This is because its function is to sense vibrations caused by engine knock or detonation. The PCM uses this signal to alter the ignition timing and prevent detonation. It will compare this information with its preset tables to identify a valid knock or ping. If a ping is sensed, it will retard the ignition timing to protect the engine from this damaging pre-ignition.

Knock Sensor

Knock Sensor,Auto Knock Sensor,High Performance Knock Sensor,Gm Car Knock Sensor

NINGBO DGOFEN AUTO TRADE CO., LTD , http://www.dgofen.com